FREQUENTLY ASKED QUESTIONS
 

QUESTIONS

     ANSWERS

 1. AFTER I FILL MY TANK WITH THE 15 TO 1 SOLUTION MY  REFRACTOMETER READS ONLY 2-3.5% IS THAT WRONG?

 2. WHY IS THEIR  A FILM ON MY PIECES WHEN I USE THE MIST COOLANT?

 3. DO THE SPINDKOOL^® PRODUCTS TEND TO CAUSE FOAMING?

4. After using a SPINDKOOL^® product my machine began to rust, what happened?

 1. NO, YOU MIGHT BE EXPECTING 6-7%, BUT THE TRANSLUCENT EFFECTS OF SPINDKOOL^® PRODUCTS DO NOT GIVE YOU A TRUE READING ON YOUR REFRACTOMETER ACCORDING TO SOLUTION. HINT, AFTER FILLING YOUR TANK TAKE A READING WITH YOUR REFRACTOMETER AND WRITE IT DOWN THAT IS THE CORRECT READING OF THE PRODUCT.

 2. THE FILM IS A CORROSION INHIBITOR AND CAN BE WIPED OFF OR REDUCE THE MIXTURE OF MIST BY ADDING MORE WATER.

 3. SOME FOAMING MAY OCCUR, BUT USED IN THE PROPER SOLUTIONS, AND UNDER THE P.S.I. RESTRICTIONS THE PRODUCT WILL PERFORM AS INTENDED.

4.  Two things could happened.  When you first cleaned your machine did you leave unprotected over night?  Having no lubricant film on machines leave them unprotected causing oxidation leading to rust.  The second condition is the mixture ratio needs to be increased with more SPINDKOOL^®.  Increasing SPINDKOOL^® to the mixture will give you more anti-corrosive properties protecting your equipment.